pc3

Not wanting to sound stupid but what are pc3

:From KN: The Power Commander is a fuel injection and ignition timing (on some models) adjustment unit that simply plugs inline with the bike's stock ECU. The PC uses original equipment style connectors so that no splicing or cutting of the harness is required. Most installations take less than 15 minutes, some as little as 5 minutes. Changes are made to the bikes fuel and ignition curves via the PC's onboard microprocessor. Using this technology Dynojet is able to offer a large area of adjustment without making any permanent changes to the bikes' ECU (electronic control unit). Removing the PC returns the bike to its previous stock condition. The Power Commander also comes complete with software and cable link that allows you to change between different maps or make adjustments to a map file. Power Commanders for some models can also control the Ignition Curve. You can adjust the ignition curve for increased part throttle response, increased peak power, or to eliminate detonation. On most models the ignition curve is close to optimum for pump fuel. In some cases it is possible to increase part throttle torque by adjusting the timing. With high octane racing fuel further gains can be realized at wide open throttle. If heavily loaded or during hot weather the PC can be adjusted to eliminate the pinging that is so common during these conditions. Here is a link to the a site whith more info: http://www.twobros.com/Perf_Products/PC/PowerCommander.shtm

Cheers for the posting, I have heard of the power commander but didn't think when I saw pc3 nevermind my new brain is in the post

I wish they were smaller!!!! ;)