MPS Tether Kill Switch

Just received my new MPS Tether Kill Switch last week. Does anyone have one of these installed on there R1. I wanted to mount it right on the clip on but there is no room. Any pics or info would be helpfull. Thanks

i have the same one and the same problem. i think i am going to make a bracket for it. did you win it or buy it?? just curious??

There is no room on either of the handlebars for a MPS Tether Kill Switch. There has to be another brand. I need one myself and will email MPS after emailing this.

Actually, it might be possible to loosen the stock starter/on off switch and slide it over a little making room for the 1/2 inch MPS Tether Kill Switch. But, the grooves for the starter/on off switch will not be aligned. I would rather get a hold of a company that has already dealt with this issue.

Originally posted by rasta1096 Actually, it might be possible to loosen the stock starter/on off switch and slide it over a little making room for the 1/2 inch MPS Tether Kill Switch. But, the grooves for the starter/on off switch will not be aligned. I would rather get a hold of a company that has already dealt with this issue. i already tried that and just won't fit:cryin

MPS suggested the following: "Much easier to move the throttle out. Either groove the bars or remove the tab."

But it looks like you need a modified bar end if you move the throttle out. I think the bar end will tighten the throttle when it is tightened back down. Oh well someone will figure something out.

I know this sound cheesy, but I mounted mine on the break resivoir brake line. It is only an 1 1/2" long and very solid. It was a last minute deal and I have left it on anyway because it looks pretty good there and works without a hitch!