Dyno Chart for the Hindle high mount (02R1)

I'm shopping for a slip-on OR a full system and I cant seem to find a dyno chart for the Hindle high mount. Can someone point me in the right direction? It will be mounted on a 2002 R1 Thanks, Mayor

well, i have a hindle highmount on my 01 rl, with the carbs rejetted, a flow commander, and ivans airbox mod. the bike makes 146 hp and 78lbft of torque. sorry, cant post the dyno sheet cause i dont have a scanner. however, the graph is very smooth from idle to redline, with a very small dip around 4 grand. how it will perform on your F/I bike with a good map remains to be seen.

ill have the high mt full on mine soon , when the can gets off back order

I have a HIndle Race on mine but I won't get it dyno'd till later on this week. JasonC has the same and did a dyno but I don't remember you can search here or go to my site and do a search to see what his numbers where.

Well below is what I got before (stock) and after installation. Now with Hindle you need to be more specific cuz they got several different variations. The have the ultra high mount, the high exit, and the standard mount. Then they have it in the 2 in pipe or in the 2.25 in race pipe. My dyno below is with the Hindle High Exit polished aluminum with 2.25 in race full system and a PCIII with the standard Hindle race map. The fuel analyzer graph circled below in yellow is where mine is running kind of rich. I need to get it custom mapped eventually. Edit: Oh by the way. This was dyno'd on an Eddie current dyno which will read about 15% below a Dynojet dyno but is apparently more consistent run to run.

The BDE is the hindle set-up you want... and his maps... I can get all the r1-forum guys 50 off... just tell him dan sent ya... Trust me you would not be sorry... my last run was a 153.9 static #... now I do have the graves products as well, but you cant argue with a solid 155 hP running down the highway ! http://home.kc.rr.com/r1abuser/dynorun2.jpg