Looking for a LINK for installing a Yamaha Cam Chain Tensioner.
How do I pre-tension the Yamaha CCT? Do I need to? Do I need to buy a 'special tool' to do the task of pre-tensioning?
you use your hands and push it in. Then use the the retainger clip, to keep it fully in. Once the tensioner is installed, it will release and tension accordingly.
you use your hands and push it in. Then use the the retainger clip, to keep it fully in. Once the tensioner is installed, it will release and tension accordingly.
The 01 only requires a narrow flat blade screwdriver. remove the cap bolt, turn the tensioner clockwise to retract it - when you remove the screwdriver it will typically release, and if it doesn't, a light tap on the outside will cause it to release.
The 01 only requires a narrow flat blade screwdriver. remove the cap bolt, turn the tensioner clockwise to retract it - when you remove the screwdriver it will typically release, and if it doesn't, a light tap on the outside will cause it to release.
Do the carbs have to come off the bike to make the CCT swap?
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Yamaha R1 Forum: YZF-R1 Forums
6M posts
157.9K members
Since 2001
R1-Forum is a Yamaha R1 motorcycle enthusiasts community dedicated to Yamaha YZF 1000 R1 sportbike. Discuss performance, customization, specs, reviews and more!