Yamaha R1 Forum: YZF-R1 Forums banner
1 - 1 of 18 Posts

· #cantstopwontstop
96 Posts
He's just telling you that if you go that route it's gonna be some DIY and in the end, may require some customization. Easy enough though, go grab some thin plate steel from Lowes or HD, measure, cut, drill, clean, spray, and install.

I did it with a custom Akrapovic underbelly exhaust, but the principle is the same.
1 - 1 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.