Yamaha R1 Forum: YZF-R1 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Ok guys. I’m wondering if this has happened to anyone else and can help me solve this. I have a 2011 R1 with toce exhaust and power commander chip. So I’ll be on a ride and about 30-40 min into the ride my check engine light comes on. Bike continues to have power but if you go to hit the throttle nothing happens. It’s stuck at an idle. So I have to pull over. Turn the bike on and off and start it back up. Sometimes I have to let it sit for a couple minutes and then I regain my throttle like nothing happened. Not sure why it’s doing this. It’s not overheating. Not sure what to do because it doesn’t happen all the time but enough to annoy me and I don’t want to get stranded somewhere. Let me know if thus has happened to you. Thanks
 

·
Astronomer not Astrologer
Joined
·
10,564 Posts
You need to tap into the tps wire to install the PCV right?

Go into diag and test both tps and aps sensors. Tell us what all 4 values are at both closed and wide open throttle. Then we will go to the next step of debugging.
 
1 - 3 of 3 Posts
Top