[marko_pn]

I finally got a chance to install GB Racing case covers. i loosen 3 bolts on clutch cover but one on the right in the middle its really hard. I need to apply a lot of pressure just to turn hex key 1/4 of a turn.
The bike has only 2000 miles, and the cluth cover was never removed.
should i just use deadly force ? :icon_mrgreen:

 

[BlackFZR]

Apply heat to the surrounding engine case, keeping the flame moving, and not stationary at one point, ensuring not to melt/burn anything. 30 seconds of heat, try to remove it again. if it doesn't move, apply more heat and try again... As they are only torqued to 10Nm, it means that it is either seized, or incorrectly loctited in.