Yamaha R1 Forum: YZF-R1 Forums banner
1 - 1 of 1 Posts

·
Ghostrider Squadron
Joined
·
9,251 Posts
dont deck.. take it to machine shop and have them put it on lapping table.. it with make sure its flat and not have to cut into it. it might remove some of material.. but not like decking it. prolly not charge u much for it. and im with Jay.. might or might not be problem.. if u use it like that..make sure to use good coats of copper coat on gasket.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top