Yamaha R1 Forum: YZF-R1 Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
173 Posts
Discussion Starter · #1 ·
Hi, on my 02 GSX-R 750 where the side plastic bolts to to the top plastic (the one with the headlight and windscreen) the bolt closest to the front of the bike ( the first one) there are like litte spider cracks starting there. I think is casued by the side fairng puting stress on it, but any way I was wondering since they are not bad yet could I smear some plastic glue or super glue on the back of the fairing to tighten it up and hold the little cracks together? they are very small but I don't want them to get worse. Thanks alot
 

· Banned
Joined
·
153 Posts
Rough up the under side of the plastic with coarse grit sandpaper and then apply some two-part epoxy to the roughed up area of the plastic. Be careful, epoxy has a tendancy to not stay where you put it. Use thin coats and check on it after about 15 mins.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top