Yamaha R1 Forum: YZF-R1 Forums banner

gregg's flushmount and libertek relay

705 Views 11 Replies 5 Participants Last post by  Jochen
Hi guys,

I have a problem with gregg's flushmount. My left flushmount doesn't do anything. The right one is flashing.
I have installed the libertek relay and I think its working well. I can adjust the flashing rate with the screw.

I have switched the flushmount and still the left one doesn't work. (so the gregg's are oke)

The red light is flashing on the relay (Is that normal if installation is done))

Is there a problem with a fuse?

I hope some one can help.

1 - 1 of 12 Posts
I suggest you follow the wire all the way to the left turn signal and make sure it is not broken or cut open and grounding. Also try switching the wires on the relay so that right goes to left and left goes to right to see if the problem stays on the left.
1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.