Yamaha R1 Forum: YZF-R1 Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter · #1 ·
Guys,

I am so close to completing my Arata rearset installs but I am stuck at the end where I am trying to connect the brake lever arm with the brake press through a locking pin. Apparently, the spacing is too large and it does not connect perfectly. I hope I described the problem here clear enough. Have any of you guys encounter this before? If so, what did you do to fix it?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top