[Primo87]

I just got a yoshimura slip-on for cheap but its only the the muffler or the can piece...the guy i bought it from said that it had previously been on an r1 similar to mine...
I was wondering if there was a way that i could use the stock pipe and just swap out the mufflers..
any ideas??? thanks

 

[jorgepelayo33]

I used a dremell to cut the rivets, then I drilled them out. I took my muffler apart and installed an A&R baffle. It's time consuming. Dremell, Power drill (not cordless drill), titanium drill bits. You can get rivets at Home Depot to replace the ones you cut. Good Luck