Yamaha R1 Forum: YZF-R1 Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
139 Posts
Discussion Starter · #1 ·
Hi,
I am trying to install flush mounts on my 2000 R1 but can't figure out how to remove the front turn signals.



Do I have to remove the middle fairing in order to access some kind of bolt that holds the turn signal?
:iamwithst

Any help is appreciated, thanks.
 

· Registered
Joined
·
139 Posts
Discussion Starter · #2 ·
okay, I figured it out :D , the way to do it is to remove the "dark grey"panel that attaches to the middle fairing, that way the base of the turn signal will be exposed. Just unscrew the metal screw that holds the base of the turn signal, and slowly wiggle the base of the turn signal loose, and eventually it will come out. :cool:
 

· My R1 eats Gixxers
Joined
·
182 Posts
The way to do it is to remove the "dark grey"panel that attaches to the middle fairing, that way the base of the turn signal will be exposed. Just unscrew the metal screw that holds the base of the turn signal, and slowly wiggle the base of the turn signal loose, and eventually it will come out. :cool:
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top