Yamaha R1 Forum: YZF-R1 Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
15,446 Posts
I doubt you can drill and tap 8mm in there...better for you to try to find some place to replace the inserts instead.

Another way would be to try a proper sized tap (original pitch) then mount a "quick-release" setup with red loktite.

There are merely small bolts without heads with a hole drilled in them in which you insert a cutter pin.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top