Yamaha R1 Forum: YZF-R1 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
I have a 2001 raptor quad with a 2001 R1 engine crammed in the frame. I had it tuned and dynoed and it put down 118hp at the rear wheels. Does this sound normal? I know I have more drag since I have to put it down through 2 wheels vs 1. Do you guys have anything you would recommed to open it up alittle.
 

·
Registered
Joined
·
33 Posts
Discussion Starter · #5 ·
I check on the dyno type but like I said i think it will be a little lower since I'm putting it through quad rear setup. If you think about it an R1 has a greesed pin it spins on as to where a quad has heavy 36" wide axle and a large round carrier barring to put it through.

I was thinking about putting a 20-30 shot of NOS on it just to give some extra kick on the hill when draging. Do you guys have good experience with NOS on these engins?

Here are some pics with my fat arse on it.




 

·
Registered
Joined
·
33 Posts
Discussion Starter · #6 ·
Bump for the N2O question. How do these engines hold up to it? I checked on the dyno and it's a dynojet. Didn't get a chance to check the compression yet it was raining all weekend.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top