Yamaha R1 Forum: YZF-R1 Forums banner
1 - 17 of 17 Posts

·
Registered
Joined
·
6,126 Posts
Discussion Starter · #1 ·
who could i take it to, i have a 2006 YAMAHA R1 and i now graves does not do it so, who could i trust.
i want it SS so i can still run GTO, Unlimited SS
 

·
Forum Moderator
Joined
·
32,430 Posts
KWS out of Charleston SC. Ask for Chip. I think they mostly do Zuks but Im sure they could hook you up.
 

·
Forum Moderator
Joined
·
32,430 Posts

·
Registered
Joined
·
6,126 Posts
Discussion Starter · #6 ·

·
INVICTUS
Joined
·
14,881 Posts
Gus,

Why don't you call Dick over at Full Spectrum and see if he can do it for you. I know he did work for Larry Pegram and he's done lots of race related work in the past. Besides that it's right around the corner from you. He's in Longwood off of 17-92. He's done work on my bike before and it was always good work.
 

·
Registered
Joined
·
6,126 Posts
Discussion Starter · #10 ·
well ill see what i do there is another guy in tally that used to race AMA, his mame is william myers (former ama rider)
i got some what a quote from him and by far cheaper than lots of ppl already.
 

·
GO Habs GO!!!
Joined
·
1,929 Posts
Yup kws does great work!! You could also try
edr performance or up here to picotte (to bad shipping would suck):)
 

·
Registered
Joined
·
6,126 Posts
Discussion Starter · #14 ·
What do you have in mind for the beast?

is going to be superstock.

balance cranked
all brand new internals OEM
deck the head, if possible valves
slot the sprockets and trying to be more exact on the timing
full tune up with u4.2
if i can y.e.c. head gasket
y.e.c. computer and wire harness.
with time ill do another motor the same way to have a spare one.
 

·
Cheating death in the "D"
Joined
·
21,068 Posts
is going to be superstock.

balance cranked
all brand new internals OEM
deck the head, if possible valves
slot the sprockets and trying to be more exact on the timing
full tune up with u4.2
if i can y.e.c. head gasket
y.e.c. computer and wire harness.
with time ill do another motor the same way to have a spare one.

The guy that does work on my bike had a superbike team, and raced himself, Scott is a motor guru, he's very well know for his motor work. His clientel consists of alot of racers, he can do anything you want, just give him your target & expectations. You know how fanatical I am with my bike and Scott is the only mechanic thats worked on my last two bikes, that in itself speaks volumes :)

PM me and I'll get you his email & phone :fact
 
1 - 17 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top