[BTurnerR1]

Hey fellas,
I just installed my Black Widow extreme mount and I have a Dussault undertail and my right turn signal is now hidden. I figure I would just put them in my tail lights. Do I need some special kit to do this or can I just do some re-wireing. Or if you have any suggestions that would be great too.:thumbup

 

[FireFighter]

You don't need any kit. I used a dremel to cut open the lens (its sealed up tight) then used some white plastic cut to cover the last three LED's on both sides. then mounted two orange bulbs that I got at wal mart in the corners and wired them to the old blinker wires. glued everything back together and remounted the tail light assembly. Takes a while but I was nervous as hell hacking on my bike. Turned out great though and people keep asking me how'd you do that? Take your time and you should be fine.

 

[jstbecauz]

uummmm...

I am assuming that you are going to install it on your 99? Then yeah you do need a kit. You can get on at your local auto parts store for about $9.00. It is a universal trailer wiring harness. If you know how to use a test light you can do it on your own, otherwise you can use the information in this link **here** either way it is very simple. About an hour job maybe with removing the rear plastics.

Good luck bro.


:thumbup

 

[FireFighter]

MY bad, Assumption is the mother of all [email protected]#$ ups. Should of checked the year, was just so excited about doing it to my 02' I just had to tell someone. Sorry about the mix up.