Yamaha R1 Forum: YZF-R1 Forums banner
1 - 12 of 12 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
I just bought a 2002 r1 and I put the stock exhaust back on but I am not sure I have the cables in the right order. Any help would be appreciated.

shane
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #3 · (Edited)
Let me describe it a little better. The cables where already connected to the exhaust side and i connected the top cable back to the solenoid on the top side closest to the motor and the bottom cable on the back side of the solenoid. The bike seems to feel sluggish after 7000 rpm like it is running real rich, but revs fine up untill 7000. I can't tell if the exup valve is opening up all the way. It used to have a PCR3 and a TIFORCE full system. Would that have an effect on the way it runs when I put the stock items back on.

shane
 

·
Action figure sold separately
Joined
·
12,213 Posts
Yes, because your bike was likely remapped with the PCRIII to run well with the TiForce full system, usually richening the a/f ratio. Now when you go back to stock, it will need to be remapped, to lean it back out.
 

·
Action figure sold separately
Joined
·
12,213 Posts
martinc said:
If you dont have the PC3 anymore,no remapping should be needed at all;you got the stock mapping in the ECU.

There is a section in the service manual to perform/check cable routing.
Good point, I don't know why I was presuming he removed the TiForce but left the PCIII in :dunno
 

·
Action figure sold separately
Joined
·
12,213 Posts
martinc said:
Too many bikes,you"re lost in data-processing at the brain level...

:lol
Oh Hell....I lost that a long time ago....LMAO :crash
 
1 - 12 of 12 Posts
Top