Yamaha R1 Forum: YZF-R1 Forums banner
1 - 1 of 1 Posts

· Wana run?
Joined
·
127 Posts
If the part is properly cleaned and the powder is properly curred you should have no problems. I use to work for a company the build IR powder coating ovens and the main thing people did wrong that ended up giving powder coating a bad name is that the parts were not properly cleaned and the powder was not properly cured long enough.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top