Yamaha R1 Forum: YZF-R1 Forums banner

1 - 7 of 7 Posts

·
Slow your roll
Joined
·
84 Posts
Discussion Starter #1
Hola!

Out of curiousity, how well would a power commander work at 5200' + with an Akro can. Would the mapping for this setup cause the bike to run too rich? I would like to get a PC3, but want to know how it will work with my current bike config.

Thanks!
JOE
 

·
Slow your roll
Joined
·
84 Posts
Discussion Starter #4
Holy smokes, $450+!!!! The Power Commanders are less then $300, why is this one so much more expensive?

How difficult is it to set the EMS system up for my bike config? My current R1 is the first FI bike I have owned.

Thanks!
JOE
 

·
Registered
Joined
·
14,085 Posts
Its expensive because :

1-its from Yosh
2-its a module on which you can connect several other goodies like power shifter,the 3 map selector and what else...
3-its from Yosh
4-its from Yosh.

Its the same as a PC3 (but with less database support)..got to be tuned on a dyno,so get rady for another couple of hundred $$ more.
 

·
Slow your roll
Joined
·
84 Posts
Discussion Starter #6
A couple hundred $$$ more on a dyno, eh? Screw that.

Thanks for the info, though!

Later,
JOE
 

·
My R1 eats everything
Joined
·
374 Posts
I would just get a PC3, download a map and ride it around. Then just tune it a bit on a laptop everytime you ride. Just don't make to many drastic changes like leaning it out to much. Bad stuff can happen pretty quick. Although I'm not sure if a PC3 allows you to adjust it THAT lean.
 
1 - 7 of 7 Posts
Top