[Rocket_Pilot]

I have just installed Sato rear sets on my '05 R1. Has anyone here installed these on their bike? What problems have you experienced with the switch/wiring?

 

[Nath]

Nothing... Cut the old sensor off and solder the wires to the new one.

The brake fluid mount is a little tight with the brake light pressure switch (the one I got sticks straight out) but it all fits ok with the right persuasion.

 

[Rocket_Pilot]

Thanks! Mine was a bit on the tight side as well.

 

[CosmoK]

I haven't had any issues, and I didn't even solder them. I just twisted them togther with a little electrical tape.