Yamaha R1 Forum: YZF-R1 Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I dont know if im searching wrong or what but can one of you guys please send me how to do the test on both the stator and the regulator rectifier


My bike will run and start perfectly after i charge the bike but after about 2 hours it completely shuts off; first the lights; then the tach and speedo; and after that it just turns off

THANKS GUYS!
 

·
Premium Member
Joined
·
37,428 Posts
check the connectors on the r/r. what year r1?
 

·
Registered
Joined
·
1 Posts
same issue stator or regulator / rectifier?

i have a 2000 r1 that will not charge while running.
after running eventually it will not start without a charge.

the battery while at rest is 12.45volts while running 12.25v at 5K.
when i check the resistance of the leads out of the stator they where 0.4 ohms for both leads.

what else should i be checking to verify what parts to replace?

thanks
~Robert
 

·
Premium Member
Joined
·
37,428 Posts
it is right next to the upper rear shock mount and beneath the battery.
 

·
NeeD 4 SpeeD
Joined
·
5,441 Posts
the regulator is connected to the plastic that holds the battery .its in front of the battery ,remove the tank and u'll see it.
there are 3 wires comming out of the stator , all 3 conneted to the regulator.
check resistance between all 3.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top