Yamaha R1 Forum: YZF-R1 Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
45 Posts
Discussion Starter · #1 ·
Want to install a clutch slider and have to remove the swing arm pivot castle nut. The only tool I see to remove it is the grave 3 in 1 tool for about 60 bucks. Does anyone know where I can get the tool cheaper? Kind of on a tight budget right now.
 

· Registered
Joined
·
45 Posts
Discussion Starter · #3 ·
Well, I got the sucker off by using a hammer and Flat head screw driver. Didn't have to hit it very hard, but If I ever decide to put it back on I think I will need the grave 3 in 1 tool.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top