Yamaha R1 Forum: YZF-R1 Forums banner
1 - 1 of 1 Posts

·
Gixxer killer
Joined
·
216 Posts
Alright, I dremeled out around my throttle tube to decrease the snappy throttle response. After that was done, I had a good amount of slack in the throttle cable. I have maxed out the adjustment on the throttle side so I then propped the tank to look at the throttle bodies side. This is where my problem lies. I can't seem to figure out how to make an adjustment at that end of the cable. I have seen people recommend this but without an explanation. Is this possible? If I order a new cable, would it be short enough to cover the extra slack?

Anyone who has purchased a new throttle cable, where does the adjuster sit when it is brand new? Is it close to the throttle tube?


WTF? to decrease snappy throttle responce. An R6 might be your solution.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top