Yamaha R1 Forum: YZF-R1 Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
401 Posts
wangsta said:
Yes it low speed slide on that side.

I need to replace the clutch cover as well is that hard to do looks like there is a seal on the bottom where the clutch cable goes in that has some leakage as well a bit.

Is the clutch cover hard to replace and slide on?

thanks for the help I will order an O ring.

oh yea its a 2002
The clutch cover isn't very difficult, the hardest part is getting the actuator rod positioned properly with the actuator gear (connected to the external lever). The manual explains it I think. A little time fiddling with it and you'll see and figure it out. Otherwise not a big deal.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top