Yamaha R1 Forum: YZF-R1 Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
1,273 Posts
Discussion Starter · #17 ·
hey guys... they both fit from 98-03 r1's. The mikuni just attaches using the lower bolt hole on the shift shaft cover where the greggs is streatched further and uses the upper bolt . I'll see if I can get a few pics. I'm probably going to hold onto both for now until I'm sure which I like.
 

· Registered
Joined
·
1,273 Posts
Discussion Starter · #22 ·
you have to spray it / wipe it down once in a while with some wd-40 and a rag.. would be a good habbit to get into every oil change. found a pic of my bike with the greggs installed. I'll try and take one with the mikuni in a couple days.

I have checked everywhere on the internet to try and find someone who sells the Mikuni but I don't think it's available. Yoyodyne used to have them for $130usd but they have discontinued them for the 98-03 R1's. Just wanted to get an idea of what it was worth. I bought it used and beat up. Had to sand and polish the hell out of it.
 

Attachments

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top