Yamaha R1 Forum: YZF-R1 Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Wrong place and miss information

11 and 12 on the on position mean Cylinder identification sensor and Crankshaft position sensor, I checked the crank sensor and reads where it should but the Cylinder identification Im not exactly sure on how to test the sensor. Still Im getting the code for the crank sensor and the sensor its working fine, just wondering what else can it be besides a short circuit and a ECU failure.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top