[Sal Khan]

I went into the FTECU software and was viewing the data stream with the engine off. I just wanted to check to make sure my throttle was fulling opening.

I noticed that it only went up to "96" (I'm guessing that's %). Is this normal? Or should it go to 100?

If is supposed to go to 100 where should I look?

Thanks.

 

[bbsteinnewyork]

I went into the FTECU software and was viewing the data stream with the engine off. I just wanted to check to make sure my throttle was fulling opening.

I noticed that it only went up to "96" (I'm guessing that's %). Is this normal? Or should it go to 100?

If is supposed to go to 100 where should I look?

Thanks.

Totally normal

Sent from my SM-G930V using Tapatalk

 

[bbsteinnewyork]

I went into the FTECU software and was viewing the data stream with the engine off. I just wanted to check to make sure my throttle was fulling opening.

I noticed that it only went up to "96" (I'm guessing that's %). Is this normal? Or should it go to 100?

If is supposed to go to 100 where should I look?

Thanks.

In fact I think FTECU should change the active tune last column to 95 so that this area gets mapped without applying the same values to 90 %

Sent from my SM-G930V using Tapatalk

 

[Sal Khan]

Totally normal

Beautiful thank you! Just wanted to make sure it was opening fully.


Sent from my iPhone using Tapatalk