I realy like the libertek, looks sweet and comes with a plate light.

 

I have one that is clear keeps the plate light but you most use aftermarket turn signals but its clean looking and IMO Sweet.


I can't find the link

 

If you want to keep the stock signals, I suggest you pick up the Graves Fender Eliminator Kit. Here is a picture of it on my bike.......
By the way, you will lose the license plate light!

 

Do you have a link to the Graves kit ? Is it really easy to install, I mean take off old, bolt on new or a lot of cutting ? Thanks

 

Do you have a link to the Graves kit ? Is it really easy to install, I mean take off old, bolt on new or a lot of cutting ? Thanks

Absolutely NO cutting involved whatsoever!! Just unbolt the stock fender, pop off the stock signals, insert the stock signals into the Graves kit, then bolt back up. The install should take no longer than 30 minutes (and that includes the time it takes to take off your tail section in the event that your hands are too big to reach the signal wires on the left side)
Sorry, but I don't have a link to the kit. I purchased it from a forum member. As a matter of fact, I think www.tobefast.com sells these kits!
Good luck and let me know if you have anymore questions.... :hellobye

 

Just saw thos on tobefast. I got the cycle-mall one with lights. Not bad but had to re-drill the holes. Just off by a little bit.

 

Hightech speed kit!!:rock
(integrated blinkers into the taillight)
Looks soo much cleaner IMO

 

PS: Ignore the garage, it's a freakin mess....I'm actually thinking about going out there and cleaning it right now.

 

Hey Twisted, I saw that one on cylce mall with the smaller blinkers and I like the look of it. What was the install like ??

 

It was easy to install, once I drilled 2 holes out a little bigger.The project should have only taken about 30-40 minutes. It's amazing how much that little mod changes the look! One other thing, the turn signals seem as bright as the originals. Thought they would be kinda hard to see. E-bay has a similar kit for $50. Check it out also.

 

Just unbolt the mud flap and drill 2 new holes on the plate that lines up with the existing holes.
Then I install tail light integrated kit by Custom LED for a clean in-the-tail blinkers.

 

Plate Brckt & Indicators-

Dynomite CF bracket on my 02, with Huge Industries indicators & Light Bolt (LED) plate light. Graves wasn't out when I got mine, but I'd recomend either Graves or Dynomite. Nice thing with both, is down the road you can switch out stock signals, the Huge Ind. indicators come with adapter plates & hole grommets to reduce stock openings to aftermarket stalk size.

 

The Custom LEDs are awesome and then you just need a tag bracket with no lights... You can check some more setups at www.tobefast.com/r102.htm

 

Rear Plate-

Pic of setup from above-

 

this is a pretty cool site that has lots of s@#$ for the 1, plus a couple sweet fender eliminators.

http://tobefast.com/r102.htm

 

Re: Rear Plate-

Pic of setup from above-

Rorlow,
Where did you get your tank cover?
Is that real carbon or look-a-like?

 

Tank Protector-

Its real CF, got it from Geelong CarbonCraft in Australia, excellent price, quality & fit. $48.00 USD.

http://www.geelongcarboncraft.com/

 

i ordered from them and they must have changed prices. mine was 95 plus shipping. came to 122