[ek-sir]

Also Ironhorz thanks homie lol,
Check the previous posts for the wiring of which wires to connect to for the main harness. Its all on here
And the Ground wire is very straight forward

Ill post my pictures of my install for a little more detailed pictures of routing and wires to tap into for speciefics, im not good at explaining so ill do my best.


Thanks for the help guys btw

First off I mounted up the dash to see how it looked
Then started checking for the wires to tap into.

Starts off with the Speed Sensor. I cut the speed sensor off and found the wires as follows and connected in,(i am soldering everything after ps.)




Next was onto The Ignition wire on the side under tank and on the right side.



This shows the general location of both connections I have tapped into. ON the right is the 2 wires for speed sensor
on the left (front of bike is where im standing taking pics) is the Ignition wire


This is the test fit and brackets of the universal mount



This is how I routed the wiring on the right side of the bike,
Wire im holding is the harness




That leads to the under tank,

Hope this helps everyone a little more if they decide to buy one

 

[ek-sir]

Ya bro, Wasnt hard at all. Just wanted to make sure but all good bro , Shawn hooked me UP

 

[ek-sir]

Have you dialed I'm the dash yet?? Just double check connections and that's wire /sensor


Sent from Motorcycle.com Free App