Wire and install LED integrated tail light

Rix · Apr 22, 2018

Hey, Mighty Men
I need some feed back on how to install a integrated tail light on 2011 R1. I bought the tail light off of EBay and when I plan to install it I must not have the correct connectors. Any advice will be much appreciated!! I load upload photos for a more understanding. When I connected the light to the plug with the green covers only one started blinking without turn the signal.

Rix · Apr 22, 2018

Here are the photos

Kevap · Apr 22, 2018

Yup... more egay crap!

XxDarkFury01xX · Apr 22, 2018

return it.

this is what i have. it's been on my bike for 4 years with no issues.

https://tstindustries.com/TST-LED-Integrated-Taillight-Yamaha-YZF-R1-2009-2014.html

tracyhudas · May 1, 2018

Just follow the old wiring set up of the old tail light but take care not to mess up the lean angle sensor.

I did an installation of tail light yesterday, i have zero ideas on how to just pure luck ??? Its very simple to follow the wirings and it was a success but messed up my lean angle sensor.hahaha lol
If you can’t start you’re bike after the installation then you know what to check ? goodluck.

Redgecko · May 2, 2018

https://www.revzilla.com/motorcycle/bike-master-turn-signal-adapters

n.e.mich · May 3, 2018

All you need to do is cut the connectors off your stock tail light, solder and shrink wrap them onto your new tail light. Takes about 20-30 minutes.
Also, you will need to solder in some resistors or install a different flasher relay (which is a lot easier).
https://www.cyclegear.com/parts/speedmetal-led-signal-relay-yamaha

ussprinceton · May 3, 2018

this is what I have

https://www.motodynamic.com/2009-2014-yamaha-yzf-r1-sequential-led-tail-lights-clear.html

Wire and install LED integrated tail light

Attachments

Top Contributors this Month

Recommended Communities